1
Place the Contour's transmission in park (automatic transmission) or very first gear (manual transmission). Engage the emergency brake and turn the ignition to the "Off" position Auto tools. Rotate the ignition back for the "On" position but usually do not get started the engine.
2
Plug the scan tool's data cable in to the Contour's diagnostic information port, underneath the dashboard just above the pedal location. Turn on the scan tool and allow it to start up.
3
Follow the instructions on the scan tool's screen to enter engine and transmission information.
4
Choose "ECU" from the main menu. Select "Codes" and "Clear all current and stored DTCs." Wait for the scan tool to indicate that the codes have been cleared.
5
Unplug the tool's data cable from the diagnostic data port. Start off the engine and ensure that the service engine light is not illuminated.
2012年9月24日星期一
2012年9月5日星期三
Tips on how to Make a VAG-COM Cable
1
Cut the 4 wire USB cable towards the desired general length as much as 9 feet using the wire cutting tool.
2
Remove 1 inch in the outer insulation on each and every finish to reveal the 4 wires inside Auto diagnostic tools. If there's a metal braided sheath defending the inner wires, fold it back away from the inner wires.
3
Using a wire cutter prevents damage to the cable. Using a wire cutter prevents damage to the cable.
Remove 1/2 inch of your insulation in the tips in the four inner wires, leaving the copper wires exposed.
4
Thread the exposed inner wires on one end in the cable into the USB connector in pin-out order. Solder the wires firmly into place and attach the outer jacket.
5
Solder attaches the wires to the connector. Solder attaches the wires to the connector.
Thread the exposed inner wires of your opposite finish with the cable into the OBD-II CAN connector Auto code scanner. Follow the same pin-out order as was used for the USB connector, with the same color wires for the data, ground and vbus. Solder the wires firmly into place and attach the outer jacket.
Cut the 4 wire USB cable towards the desired general length as much as 9 feet using the wire cutting tool.
2
Remove 1 inch in the outer insulation on each and every finish to reveal the 4 wires inside Auto diagnostic tools. If there's a metal braided sheath defending the inner wires, fold it back away from the inner wires.
3
Using a wire cutter prevents damage to the cable. Using a wire cutter prevents damage to the cable.
Remove 1/2 inch of your insulation in the tips in the four inner wires, leaving the copper wires exposed.
4
Thread the exposed inner wires on one end in the cable into the USB connector in pin-out order. Solder the wires firmly into place and attach the outer jacket.
5
Solder attaches the wires to the connector. Solder attaches the wires to the connector.
Thread the exposed inner wires of your opposite finish with the cable into the OBD-II CAN connector Auto code scanner. Follow the same pin-out order as was used for the USB connector, with the same color wires for the data, ground and vbus. Solder the wires firmly into place and attach the outer jacket.
订阅：
博文 (Atom)